Fire-Lite's SD355 and SD355T addressable, low-profile, plug-in photoelectric detectors use a state of the art photoelectric sensing chamber to provide open area protection and are used exclusively with the MS-9050UD, MS-9200UDLS, and MS-9600(UD)LS Addressable Fire Alarm Control Panels. The SD355T adds thermal sensors that will alarm at a fixed temperature of 135F (57C).
Fire-Lite's CP355 addressable, low-profile, plug-in ionization detector uses a state-of-the-art ionization sensing chamber to provide open-area protection and is used exclusively with Fire-Lite’s MS-9050UD, MS-9200UDLS, and MS-9600(UD)LS Addressable Fire Alarm Control Panels. The ionization detector is used to sense products of combustion and report the measured level to the panel.
Fire-Lite's H355 Series thermal detectors are addressable sensors that use a state-of-the-art thermistor sensing circuit for a fast response. These sensors are designed to provide open area protection and are intended for use with Fire-Lite’s MS-9050UD, MS-9200UDLS, and MS-9600(UD)LS Addressable Fire Alarm Control Panels. Both the H355 and H355R provide fixed temperature alarm detection at 135F. The H355HT provides fixed-high temperature detection.
Fire-Lite's AD355 Adapt detector is an intelligent, addressable, multi-sensing, low-profile detector designed for use with the Addressable Fire Alarm Control Panels. The Adapt detector combines photoelectric and thermal sensing technologies designed to increases immunity to false alarms.
Fire-Lite's B501(A), B210LP(A), B200SR(A), B200SR-FL and B224RB(A) intelligent mounting bases and kits provide a variety of ways to install Fire-Lite detectors in any application.
Fire-Lite's InnovairFlex D355PL non-relay photoelectric duct smoke detector features a pivoting housing that fits both square and rectangular footprints capable of mounting to a round or rectangular duct. The InnovairFlex duct smoke detector senses smoke in the most challenging conditions, operating in air flow speeds of 100 to 4,000 feet per minute, temperatures of -4 degrees F to 158 degrees F, and a humidity range of 0 to 95 percent (non-condensing).
Fire-Lite's BEAM355 and BEAM355S are intelligent, addressable projected beam smoke detectors for protecting open areas with high and sloping ceilings, and wide-open areas, where spot-type smoke detectors are difficult to install and maintain.
The HFS-P is a photoelectric smoke detector. This plug in smoke detector, with integral communication, provides features that surpass conventional detectors and are for use with Fire-Lite MS-25 (E) Fire Alarm Control Panel.
The HFS-PT is a photoelectric smoke detector with thermal. This plug in smoke detector, with integral communication, provides features that surpass conventional detectors and are for use with Fire-Lite MS-25 (E) Fire Alarm Control Panel.
The HFS-D Intelligent Non-Relay air duct smoke detector comes with the sensor head factory installed. HFS-D is used for detecting smoke and products of combustion present in air moving through an HVAC air handling system. When smoke is detected in a duct, the unit communicates the condition to the Fire-Lite MS-25 (E) Fire Alarm Control Panel. The panel, in turn, depending on programming and wiring, turns off fans, blowers, and other devices.
The HFS-T is an Intelligent sensor with a plug-in detector base that utilizes a state-of-art thermistor sensing circuit for fast response. This thermal sensor is for use with Fire-Lite MS-25 (E) Fire Alarm Control Panel.